Volt

This page uses content from the English Wikipedia. The original article was at Volt. The list of authors can be seen in the page history. As with the Units of Measurement Wiki, the text of Wikipedia is available under Creative Commons License see Wikia:Licensing.

NISTvoltChip — Josephson junction array chip developed by NIST as a standard volt

The volt (symbol: V) is the SI derived unit for electric potential, electric potential difference, and electromotive force.^[1] The volt is named in honor of the Italian physicist Alessandro Volta (1745–1827), who invented the voltaic pile, possibly the first chemical battery.

Definition[]

A single volt is defined as the difference in electric potential across a wire when an electric current of one ampere dissipates one watt of power.^[2] It is also equal to the potential difference between two parallel, infinite planes spaced 1 meter apart that create an electric field of 1 newton per coulomb. Additionally, it is the potential difference between two points that will impart one joule of energy per coulomb of charge that passes through it. It can be expressed in terms of SI units as follows:

\mbox{V} = \mbox{A} \cdot \Omega= \dfrac{\mbox{W}}{\mbox{A}} = \sqrt{\mbox{W} \cdot \Omega} = \dfrac{\mbox{J}}{\mbox{A} \cdot \mbox{s}} = \dfrac{\mbox{N} \cdot \mbox{m} }{\mbox{A} \cdot \mbox{s}}  = \dfrac{\mbox{kg} \cdot \mbox{m}^2}{\mbox{C} \cdot \mbox{s}^2} = \dfrac{\mbox{N} \cdot \mbox{m}} {\mbox{C}} = \dfrac{\mbox{J}}{\mbox{C}}

It can also be written using only the SI base units m, kg, s, and A as:

\mbox{V} = \dfrac{\mbox{kg} \cdot \mbox{m}^2}{\mbox{A} \cdot \mbox{s}^{3}}

Josephson junction definition[]

Between 1990 and 1997, the volt was calibrated using the Josephson effect for exact voltage-to-frequency conversion, combined with cesium-133 time reference, as decided by the 18th General Conference on Weights and Measures. The following value for the Josephson constant is used:

K_{J-90} = 2e/h = 0.4835979 GHz/µV.

This is typically used with an array of several thousand or tens of thousands of junctions, excited by microwave signals between 10 and 80 GHz (depending on the array design).^[3] Empirically, several experiments have shown that the method is independent of device design, material, measurement setup, etc., and no correction terms are required in a practical implementation.^[4] However, as of July 2007, this is not the official BIPM definition of Volt.^[5]

Water flow analogy[]

In the water flow analogy sometimes used to explain electric circuits by comparing them to water-filled pipes, voltage difference is likened to water pressure difference–the difference determines how quickly the electrons will travel through the circuit. Current (in amperes), in the same analogy, is a measure of the volume of water that flows past a given point per unit time (volumetric flow rate). The flow rate is determined by the width of the pipe (analogous to electrical conductivity), and the pressure difference between the front end of the pipe and the exit (analogous to voltage). The analogy extends to power dissipation: the power given up by the water flow is equal to flow rate times pressure, just as the power dissipated in a resistor is equal to current times the voltage drop across the resistor.

The relationship between voltage and current (in ohmic devices) is defined by Ohm's Law.

Common voltages[]

can be used to measure the voltage between two positions.]]

Nominal voltages of familiar sources:

Nerve cell resting potential: around −75 mV^[6]
Single-cell, rechargeable NiMH or NiCd battery: 1.2 V
Mercury battery: 1.355 V
Single-cell, non-rechargeable alkaline battery (e.g., AAA, AA, C and D cells): 1.5 V
LiFePO₄ rechargeable battery: 3.3 V
Lithium polymer rechargeable battery: 3.75 V (see Rechargeable battery#Table of rechargeable battery technologies)
Transistor-transistor logic/CMOS (TTL) power supply: 5 V
PP3 battery: 9 V
Automobile electrical system: nominal 12 V, about 11.8 V discharged, 12.8 V charged, and 13.8–14.4 V while charging (vehicle running).
Household mains electricity: 230 V RMS in Europe, Asia and Africa, 120 V RMS in North America, 100 V RMS in Japan (see List of countries with mains power plugs, voltages and frequencies)
Trucks/lorries: 24 V DC
Rapid transit third rail: 600–750 V (see List of current systems for electric rail traction)
High-speed train overhead power lines: 25 kV RMS at 50 Hz, but see the list of current systems for electric rail traction and 25 kV at 60 Hz for exceptions.
High-voltage electric power transmission lines: 110 kV RMS and up (1.15 MV RMS was the record as of 2005
Lightning: Varies greatly, often around 100 MV.

Note: Where RMS (root mean square) is stated above, the peak voltage is $\sqrt{2}$ times greater than the RMS voltage for a sinusoidal signal centered around zero voltage.

History of the volt[]

File:Alessandro Volta.jpeg

Alessandro Volta

In 1800, as the result of a professional disagreement over the galvanic response advocated by Luigi Galvani, Alessandro Volta developed the so-called Voltaic pile, a forerunner of the battery, which produced a steady electric current. Volta had determined that the most effective pair of dissimilar metals to produce electricity is zinc and silver. In the 1880s, the International Electrical Congress, now the International Electrotechnical Commission (IEC), approved the volt as the unit for electromotive force. At that time, the volt was defined as the potential difference [i.e., what is nowadays called the "voltage (difference)"] across a conductor when a current of one ampere dissipates one watt of power.

The international volt was defined in 1893 as 1/1.434 of the emf of a Clark cell. This definition was abandoned in 1908 in favor of a definition based on the international ohm and international ampere until the entire set of "reproducible units" was abandoned in 1948.

Prior to the development of the Josephson junction voltage standard, the volt was maintained in national laboratories using specially constructed batteries called standard cells. The United States used a design called the Weston cell from 1905 to 1972.

References[]

↑ "SI Brochure, Table 3 (Section 2.2.2)". BIPM. 2006. http://www.bipm.org/en/si/si_brochure/chapter2/2-2/table3.html. Retrieved 2007-07-29.
↑ BIPM SI Brochure: Appendix 1, p. 144
↑ Burroughs, Charles J.; Benz, Samuel P. (1999-06-01), "1 Volt DC Programmable Josephson Voltage Standard", IEEE transactions on applied superconductivity 9 (3): 4145–4149, ISSN 1051-8223, http://www.nist.gov/cgi-bin/view_pub.cgi?pub_id=15238
↑ Keller, Mark W (2008-01-18), "Current status of the quantum metrology triangle", Metrologia 45 (1): 102–109, wikipedia:Bibcode 2008Metro..45..102K, doi:10.1088/0026-1394/45/1/014, ISSN 0026-1394, http://qdev.boulder.nist.gov/817.03/pubs/downloads/set/Metrologia%2045,%20102.pdf, "Theoretically, there are no current predictions for any correction terms. Empirically, several experiments have shown that K_J and R_K are independent of device design, material, measurement setup, etc. This demonstration of universality is consistent with the exactness of the relations, but does not prove it outright."
↑ http://www.bipm.org/en/si/si_brochure/chapter2/2-1/
↑ Bullock, Orkand, and Grinnell, pp. 150–151; Junge, pp. 89–90; Schmidt-Nielsen, p. 484

External links[]

See also wiktionary:Volt in Wiktionary, the free dictionary
Google Video Lecture about Electricity and Volt by Richard A. Muller
Electricity Electric Field Strength Tool

[1] "SI Brochure, Table 3 (Section 2.2.2)". BIPM. 2006. http://www.bipm.org/en/si/si_brochure/chapter2/2-2/table3.html. Retrieved 2007-07-29.

[2] BIPM SI Brochure: Appendix 1, p. 144

[3] Burroughs, Charles J.; Benz, Samuel P. (1999-06-01), "1 Volt DC Programmable Josephson Voltage Standard", IEEE transactions on applied superconductivity 9 (3): 4145–4149, ISSN 1051-8223, http://www.nist.gov/cgi-bin/view_pub.cgi?pub_id=15238

[4] Keller, Mark W (2008-01-18), "Current status of the quantum metrology triangle", Metrologia 45 (1): 102–109, wikipedia:Bibcode 2008Metro..45..102K, doi:10.1088/0026-1394/45/1/014, ISSN 0026-1394, http://qdev.boulder.nist.gov/817.03/pubs/downloads/set/Metrologia%2045,%20102.pdf, "Theoretically, there are no current predictions for any correction terms. Empirically, several experiments have shown that K_J and R_K are independent of device design, material, measurement setup, etc. This demonstration of universality is consistent with the exactness of the relations, but does not prove it outright."

[5] ttp://www.bipm.org/en/si/si_brochure/chapter2/2-1/

[6] Bullock, Orkand, and Grinnell, pp. 150–151; Junge, pp. 89–90; Schmidt-Nielsen, p. 484

[1]

[2]

[3]

[4]

[5]

[6]